Step By Step Instructions

Note: for a good fit, you can bene the LOVE link with your round nose pliers to fit your wrist. Also, the units in Step 1 may be eliminated for a shorter length  bracelet.

1. Make two of these units: On a nickel-free brass eyepin, stack the following: a  brass beadcap, a small faceted rondelle crystal bead, and another brass beadcap. Make a simple loop at the end of the headpin.
2. Make six of of these units: On a nickel-free brass eyepin, place a Czech Glass Baroque Bicone. Make a simple loop at the other end of the eyepin.
3. If needed, trim any excess wire with flush cutters.
4. Make a small chain of three of the units you made in Step 2, opening and closing the connecting loops as you go. 
5. Repeat Step 3, making another small chain of the other three units you made in Step 2.
6. Open a large brass jump ring and attach to one end of the chain in Step 2.  Attach the brass LOVE link and close the large jump ring.
7. Repeat Step 5, using the large jump ring to attach the other end of the brass LOVE link to the other piece of chain you  made in Step 3.
8. On each open end of the unit you have made, attach one of the units you made in Step 1, by opening and closing the loops on the chain.
9. Open a small brass jump ring.  On one open end of the unit you have made, connect one half of the magnetic barrel clasp to the jump ring and the small crystal unit you made in Step 1. Close the jump ring.
10. Repeat Step 8 to finish the bracelet.

CONGRATULATIONS! You are now ready to wear your beautiful new bracelet, or give it to someone you love!